
Chapter 03: Battery Usage and Care 37
2. Disconnect the AC adapter and power on the tablet. Let the
batteries run down until the system automatically enters the
Suspend/Hibernation mode and shuts down.
3. Reconnect the AC adapter, let the batteries fully charge
(so both battery indicators glow green) and then run the
computer with the external power still connected for at
least a few hours before unplugging and running on battery
power.
The battery packs should now be properly calibrated. If you
find that battery life doesn’t correspond to the battery status as
reported by your operating system, repeat steps 2 -3 again.
If after performing a calibration for a second time you still find
you are having a problem with the battery life, you will need to
go into the BIOS and perform a battery calibration.
1. To enter the BIOS, power on or restart your Sahara NetSlate
and press the L2 (Screen Rotation) button as soon as you see
the TabletKiosk logo.
2. Once in the BIOS, use the L3 button to navigate over to the
Advanced menu screen.
3. Use the L4
button to go
down to the
BAT Calibra-
tion item.
4. Press the R2
button to enter
the Calibration
routine. Make
sure the Sa-
hara NetSlate
is attached to the AC Adapter and that the AC adapter is
plugged into an external power source and then press any
function button (except L1 and R1) to begin the calibration.
BIOS SETUP UTILITY
v02.69 (C)Copyright 1985-2010, American Megatrends, Inc.
Main Advanced Boot Security Exit
Advanced Settings
IDE Configuration
AHCI Configuration
Trusted Computing
BAT Calibration
FAN Calibration
Wake On LAN From S4/S5 [Disable]
Left Programmable Button 3/4 [Volume Up/Down]
Bootup Num-Lock [Off]
Configure the IDE
device(s).
Select Screen
Select Item
+- Change Field
Tab Select Field
F1 General Help
F10 Save and Exit
ESC Exit
Comentarios a estos manuales